Emphatec Inc
Profile
Emphatec offers DC Power Supplies, AC Power Distribution and Power Protection products. Our interface modules include Analog Signal Conditioners, High-density Discrete Interfaces, C1 D2 products, I/O Interface Adapters for Control System Migration applications, as well as, the capability to provide innovative Custom-Engineered control solutions.
Address
10A Spy Court
Markham, ON L3R 5H6
Canada
Phone: 1-905-475-0220
Fax: 1-905-475-8117
Products
Name: DEPRO®- QTD
Description: DEPRO- QTD (Quarter-Turn Disconnect) modules are designed for use in low current (up to 1A) applications, providing an easy means of temporarily disconnecting (under load) a signal.
Details:
The DEPRO- QTD (4 versions are available) disconnect, is operated using a screwdriver and can be secured in the open position. Best of all these disconnects can be operated under load in Class1 Division 2 and Zone 2 hazardous locations.
Name: DEPRO® - FM5/8
Description: The DEPRO- FM5/8 modules provide power distribution & fusing in one convenient package and are Class 1 Division 2 / Zone 2 certified.
Details:
DEPRO-FM5/8 (two 8-CH versions available) modules include sockets for eight, 5 x 20mm fuses, under protective covers and LED's to show status of each fuse.
Fuses up to 4A can be installed (fuses not provided with modules) but the total current drawn from all 8-channels cannot exceed 30A.
Note: DEPRO-FM5/1 (two 1-CH versions are also available.
Name: DEPRO® - ADM
Description: DEPRO -ADM (Active Diode Module) provides the function of a diode but does not contain a diode. The ADM is used to provide isolation, when multiple power supplies are connected in parallel for redundancy or increased capacity.
Details:
Diodes are often used and connected to the output of a power supply to isolate the supply, in event of an internal failure.
The DEPRO-ADM (C1D2 / Zone 2 approv.) replaces the diode with a MOSFET configured to behave like a diode and lowers the voltage drop to 50mV maximum. This means 1.25W of power dissipation at 25A versus 7.5 -17.5W when traditional diodes are used for isolation.
The result is a cooler control cabinet and a higher ambient operating temperature for the ADM.
External Link
