File:Yamato1 1.jpg
The Yamato 1 on display in Kobe, Japan. The first known working prototype.
File:Yamato 1 from the front.JPG
The front of the Yamato 1
File:Yamato 1 thruster.jpg
A MHD thruster from the boat, at the Ship Science Museum in Tokyo.
File:Magnetohydrodynamic drive tube.jpg
A view through a tube in the thruster off Yamato I, at the Ship Science Museum in Tokyo. The electrode plates are visible top and bottom
File:Magnetohydrodynamic drive.jpg
A view of the end of the thruster unit from Yamato I, at the Ship Science Museum in Tokyo.

A magnetohydrodynamic drive or MHD propulsor is a method for propelling seagoing vessels using only electric and magnetic fields with no moving parts, using magnetohydrodynamics. The working principle involves electrification of the propellant (gas or water) which can then be directed by a magnetic field, pushing the vehicle in the opposite direction. Although some working prototypes exist, MHD drives remain impractical.

Principle

Ship propulsion

An electric current is passed through seawater in the presence of an intense magnetic field, which interacts with the magnetic field of the current through the water. Functionally, the seawater is then the moving, conductive part of an electric motor. Pushing the water out the back accelerates the vehicle in the forward direction.

The physics equation describing this propelling force is Fmag = I (L × B) where L is the vector in the direction of the current 'I' and its length is the distance the current travels, B is the magnetic field, and × denotes the cross product.

MHD is attractive because it has no moving parts, which means that a good design might be silent, reliable, efficient, and inexpensive.

The major problem with MHD is that with current technologies it is more expensive and much slower than a propeller driven by an engine[citation needed]. The extra expense is from the large generator that must be driven by an engine. Such a large generator is not required when an engine directly drives a propeller. However, a battery system would allow a hybrid marine ship with potential for high efficiency and lower emissions. Additionally, the MHD design eliminates many of the wear and friction pieces of the drivetrain with a directly driven propeller by an engine.

Spacecraft propulsion

A number of experimental methods of spacecraft propulsion are based on magnetohydrodynamic principles. In these the working fluid is usually a plasma or a thin cloud of ions. Some of the techniques include various kinds of ion thruster, the magnetoplasmadynamic thruster, and the variable specific impulse magnetoplasma rocket.

Prototypes

The first prototype of this kind of propulsion was built and tested in 1965 by Steward Way, a professor of mechanical engineering at the University of California, Santa Barbara. Way, on leave from his job at Westinghouse Electric, assigned his senior year undergraduate students to develop a submarine with this new propulsion system.[1] In 1991, another prototype, the Yamato 1, was completed in Japan by the Ship & Ocean Foundation (later known as the Ocean Policy Research Foundation). The ship was first successfully propelled in Kobe harbour in June 1992. Yamato 1 is propelled by two MHD thrusters that run without any moving parts.[citation needed]

Fiction

"Oregon", a ship in the Oregon Files series of books by author Clive Cussler, has a magnetohydrodynamic drive. In Valhalla Rising, Clive Cussler writes the same drive into the powering of Captain Nemo's Nautilus.

The film adaptation of The Hunt for Red October popularized the magnetohydrodynamic drive as a "caterpillar drive" for submarines, an undetectable "silent drive" intended to achieve stealth in submarine warfare. In reality, the current traveling through the water would create gases and noise, and the magnetic fields would induce a detectable magnetic signature. In the novel, of which the movie was an adaptation, the caterpillar was a pumpjet.

See also

References

  1. Script error